Monday, 27 May 2019

Multicolor powder foil hot stamping paper

Multicolor powder foil hot stamping paper
Product Name: Multi-color powder foil hot stamping paper
Product specifications: 12μ*64cm*120m, can also be customized according to customer requirements.
Product standard packaging: 6 rolls / box.



Friday, 17 May 2019

Printed material PU swimsuit high tensile thick plate pulp


Flower material PU material description

characteristic:
    The PU material of printing material is mostly used for nylon, luggage, waterproof fabric and shoe material. It has the characteristics of high fastness, strong stereoscopic effect, high copying rate and no netting.

application:

    1. Make 80-120 mesh mesh of thick plate, if the number of times is lithographic printing, the number of times should be increased;

    2. Print to the required height in sections, printing → drying → printing → drying. The finished product is naturally dried or dried at 100 ° C ~ 120 ° C;

    3. If you need to increase the fastness, you can add the cross-linking agent CX-100 in an appropriate amount. After mixing, stir well. The adjusted slurry needs to be used up the same day.
This product belongs to the glue produced by acrylic modified polyurethane resin. It is a cost-effective product developed according to the requirements of high market demand, high fastness, washable water, good hand feeling, high elasticity and softness. Suitable for all kinds of cotton, T/C cloth.
Printing material
Product introduction ▼
 
     
   Ingredients: PUA copolymer, powder, auxiliary.
   Appearance: light blue and white paste
   Ionicity: anion/nonion
   PH value: 6-8
   Viscosity: 60000-80000 cps
   Water solubility: can be diluted with water in any ratio


Thick board product traits ▼

 
    1. The printing material is non-toxic, non-formaldehyde and APEO, completely environmentally friendly. Meet the European and American environmental requirements.
    2. High elasticity, self-crosslinking at room temperature, soft hand feeling and excellent washing fastness.
    3. No netting, no anti-sticking, high gloss, strong stereo.


Application Details ▼
 
    1. Suitable for all kinds of cotton, T/C cloth, with high fastness, strong stereo effect, etc.
    2. If there is special requirement for washing fastness, it is recommended to add cross-linking agent appropriately. The general amount is: 1.5%--2.5%
    3. It is used with our company's glue. The dosage is different according to the requirements.


Packaging and Storage ▼

    50KG blue PE barrel lined with double PE plastic bags. Store at room temperature and protected from light for 6 months.
The storage safety period after opening is requested by the customer.

Digital direct spray printing primer



Digital base slurry detailed description

One: performance

Very soft to the touch, good elasticity, dry and non-sticky surface
Good adhesion, improve the flexibility of white glue

Two: process

NT-2 digital primer is used to make a three-knife bottoming, and the flashing machine can be baked for 7 seconds.
Then print NT-1 white glue three times a knife, bake the oven for 7 seconds to dry, then print NT-1 white glue again, immediately inkjet
After the inkjet is finished, the flash dryer is baked for 7 seconds, and then covered with a special cover slurry NT-4.
After the NT-4 cover is printed, the flash dryer can be baked for 7 seconds.
After 12 hours of natural drying or pre-bake at 120 ° C for 2 minutes, then heat the furnace at 150-160 ° C for 2-3 minutes to make the ink completely dry and cure.