Friday, 17 May 2019

Digital direct spray printing primer



Digital base slurry detailed description

One: performance

Very soft to the touch, good elasticity, dry and non-sticky surface
Good adhesion, improve the flexibility of white glue

Two: process

NT-2 digital primer is used to make a three-knife bottoming, and the flashing machine can be baked for 7 seconds.
Then print NT-1 white glue three times a knife, bake the oven for 7 seconds to dry, then print NT-1 white glue again, immediately inkjet
After the inkjet is finished, the flash dryer is baked for 7 seconds, and then covered with a special cover slurry NT-4.
After the NT-4 cover is printed, the flash dryer can be baked for 7 seconds.
After 12 hours of natural drying or pre-bake at 120 ° C for 2 minutes, then heat the furnace at 150-160 ° C for 2-3 minutes to make the ink completely dry and cure.

No comments:

Post a Comment